There is no need to lay a cement layer, and it can be directly buried under the 8-10mm adhesive of the ground decoration material. Flexible laying, easy installation, easy standardization and operation, suitable for various floor decoration materials. Whether it is a concrete floor, wooden floor, old tile floor or terrazzo floor, it can be installed on the tile glue with little effect on the ground level.
1. Double conduction heating cable floor heating pad
There is no need to lay a cement layer, and it can be directly buried under the 8-10mm adhesive of the ground decoration material. Flexible laying, easy installation, easy standardization and operation, suitable for various floor decoration materials. Whether it is a concrete floor, wooden floor, old tile floor or terrazzo floor, it can be installed on the tile glue with little effect on the ground level.
product name | Double conduction heating cable floor heating pad |
product brand | Qingqi Dust Environmental |
outer sheath | Polyvinylidene Fluoride (FEP) |
Ground wire | copper wire |
Shield | Aluminum foil + copper wire |
inner conductor | Alloy resistance wire + copper wire |
Internal insulation | Polyvinylidene Fluoride (FEP) |
connector type | external connector |
The design should be standardized and scientific, and the heat loss calculation should be correct. The power should not be reduced in order to meet the user's low-cost expectations or increased in order to make the heating effect obvious. Design power standard requirements: (area: 30cm-50cm thick wall + insulation, 3 meters high, residential building for heating) per square meter (heating area) selection design power density average: about 150W/m², bathroom 180W/m° . The difference rate in the north-south direction, the adjustment ratio after the comparison of heat transfer between households, and the adjustment rate used in other functional areas are all around 5%.