Without laying a cement layer, it can be directly buried under the adhesive of 8-10mm of ground decoration materials. It is flexible in laying, easy to install, easy to standardize and operate, and suitable for various ground decoration materials.Whether it is a concrete floor, a wooden floor, an old ceramic tile floor or a terrazzo floor, it is installed in a ceramic tile adhesive and has little effect on the elevation of the ground.
1. Introduction of Double-guide heating cable floor heating mat
Without laying a cement layer, it can be directly buried under the adhesive of 8-10mm of ground decoration materials. It is flexible in laying, easy to install, easy to standardize and operate, and suitable for various ground decoration materials.Whether it is a concrete floor, a wooden floor, an old ceramic tile floor or a terrazzo floor, it is installed in a ceramic tile adhesive and has little effect on the elevation of the ground.
Product Name | Double-guide heating cable floor heating mat |
Product Brand | Qingqi Dust Environmental |
Outer sheath | polyvinylidene fluoride (FEP) |
Grounding wire | copper wire |
Shielding layer | aluminum foil + copper wire |
Inner conductor | alloy resistance wire + copper wire |
Internal insulation | polyvinylidene fluoride (FEP) |
Connector type | External connector |
The design should be standardized and scientific, the heat loss calculation should be correct, and the power should not be reduced in order to meet the user's low-cost expectations or the power should be increased in order to make the heating effect obvious.Design power standard requirements: (area: 30cm-50cm thick wall + thermal insulation, 3 meters high, residential buildings for heating purposes) per square meter (heating area) selection design power intensive mean: about 150W/m?,Bathroom 180W/m°.The difference rate between the north and south directions, the adjustment ratio after the comparison of heat transfer between households, and the adjustment of the use of other functional areas are about 5% each.